Summit SPR627OSCSS Bedienungsanleitung PDF herunterladen (Seite 8)

overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug the

appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the

receptacle. Repair or replace immediately all power cords that have become frayed or otherwise

damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.

When moving the appliance, be careful not to damage the power cord.

EXTENSION CORD

Because of potential safety hazards under certain conditions, it is strongly recommended that you do not

use an extension cord with this appliance. However, if you must use an extension cord, it is absolutely

necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding

type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes.

REVERSING THE DOOR SWING OF YOUR APPLIANCE

This unit has the capability of the door opening from either the left or right side. The unit is delivered to

you with the door opening from the left side. Should you desire to reverse the opening direction, please

follow the reversal instructions shown below.

NOTE: All parts removed must be saved to allow the door swing to be reversed.

1. Remove the bottom hinge (2) by unscrewing the four lock screws (1). Be careful to hold the door

firmly after removing the screws. (Fig. 1)

2. Gently pull down to remove the door from the right top hinge and place it on a padded surface to

avoid the risk of damage. Then remove the right top hinge (7). (Figs. 2 & 3)

3. Unscrew and transfer pins (4) and(3) of the hinge plate to the opposite side. (Fig. 1)

4. Pop out the cover caps on the left side of cabinet and use them to cover the screw holes on the right

hand side.

5. Screw the alternative left top hinge (8), included in the fittings, on the left hand side of cabinet. (Fig. 3)

6. Relocate the door to the designated position. Then screw the bottom hinge assembly on the left

designated position and tighten it after the door is leveled. (Fig. 1)

7. Remove the handle from the left side of the door and install it on the right side. (See next section.)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Summit SPR627OSCSS Bedienungsanleitung Seite 8